Spooky2 Rife System
BIOFEEDBACK
- Can l do a grade scan using Contact and then run BFB results using PEMF Coil?
- Can the Spooky2 Pulse Finger Clip and Ear Clip work on GenX/GX Pro?
- Can l use Spooky2 Cold Laser devices to do Biofeedback Scans?
- What is the difference between Terrain and Biofeedback Scan?
- Is it possible to run biofeedback via XM without anyone helping to set up and initiate scans?
- How to look up frequencies in the result of reverse lookup?
- See all 228 articles
Spooky2-XM Generators
- Is there any difference between a 5MHz XM generator and a 20MHz XM generator?
- How much space should be in between each XM generator?
- What does ON/OFF on screen of generator mean?
- Can a single XM run multiple frequencies as a group all at once?
- What the single grey knob on XM is about or where it's supposed to be pointing?
- I have two XMs up and running with one program on each one. Can I turn off the side that doesn't have the remote?
- See all 193 articles
Spooky Central
- Can l put XM and/or laptop on top of the Spooky2 Central?
- Can Spooky2 Central be useful without Phanotron plasma tubes?
- Can you set up Spooky2 Central on its side?
- Can Spooky2 Central be plugged into the same ups system as the generator?
- What is the meaning of “Is Spooky2 Central/Plasma always connected to Generator 9”?
- Can l connect both GX and XM to one Spooky2 Central?
- See all 341 articles
GeneratorX
- Why does GenX display occasionally flicker/dim rapidly once in a while?
- Can I run Plasma on G1 and sync contact mode on G2?
- Does the GX need to be cleared or reset after each use?
- Why can’t l load Daily Wellness onto my GX?
- Why do OUT1 and OUT2 of the same port show 2 different frequencies?
- Is there a little red fork-looking thing in the corner, how do l fix it?
- See all 168 articles
Spooky PEMF Coil
- What is the advantage of using the PEMF coil over other modes of transmission?
- Can Spooky2 PEMF Coil be used with MW frequencies?
- Can I use a paper cup on top of Spooky2 PEMF Coil for imprinting?
- What is the frequency range of the Spooky PEMF coil?
- What is the difference between MiraMate Big Magic PEMF and the Spooky2 PEMF coil?
- What's the difference between the PEMF coil for GenX and the PEMF coil for Central?
- See all 41 articles
Spooky2 Software (20160803 and above)
- Can l change the valve of Age Factor to fasten the program?
- How can l get Spooky2 software into "Dark Mode"?
- Is there a difference between "pause" and "hold" on the Control screen?
- Can we set various presets to run for different lengths of time in a chain?
- What are the presets under DNA targeting at?
- How to copy and paste my BFB scans from one computer to another?
- See all 440 articles
Spooky Cold Laser
- How can l clean Spooky2 Cold Laser Twins?
- Which one is more effective as a blood purifier: Spooky2 Cold Laser Wrist X or MicroGen?
- Can you use the cold laser on your neck?
- Can I run program "blood cleanser cancer" with cold laser wrist?
- Can I run both cold laser twin and wrist at the same time?
- Can you use cold laser with MW program?
- See all 101 articles
Spooky2 Software
- Is there a setting to remove harmful substances when adding minerals?
- Why DNA programs have no frequencies shown on the screen?
- How do I delete these programs in the middle Box of the Presets tab?
- On the Control tab, do Out1 and Out2 frequencies always match?
- More information about Superprogram 1, Superprogram 2 and Superprogram 3.
- How much space is required to download the Spooky2 software?
- See all 459 articles
Spooky Pulse
- After pulse-scan for minus (healing) frequencies, do l need to analyze the results for angle and angle + current or just to run them without analyzing?
- Is it recommended that you use pulse with USB hub?
- Why is the green light on Pulse visible but no BPM detected?
- Can you make the pulse sensor less sensitive?
- Is there any way to speed up the process of Pulse Scan?
- My biofeedback scan pulse spent long time, is that normal? Do I need to use the scan every day or can I keep using the same results for some day on and off?
- See all 177 articles
Spooky Remote
- Is imprinted holographic sticker the same as using Spooky2 Remote?
- Is it good to use a one-week frozen nail piece as a DNA sample in the Remote?
- What does “For an energetic treatment, place the Spooky2 Remote BESIDE YOUR LEFT FOREARM” mean?
- What is the maximum amplitude setting you can run for a remote program?
- We should run programs for a maximum of 4 hours. What if a chain takes more than 4 hours?
- Can I use a piece of my hair with the fingernails?
- See all 323 articles
Pad/Contact
- What's the difference between Spooky2 Tens Pads and Hand Cylinders?
- Can l use glue to stick the Spooky2 TENS Pads?
- Where should we place the TENS Pads for Spinal Pain?
- What is the frequency limit for Spooky2 Contact Mode?
- What is the best placement of the TENS pads for mitral valve prolapse programs?
- Where do you place TENS PADS for ear infection?
- See all 273 articles
Spooky Boost
- Is BN port on Spooky2 Boost just a straight extension of BN port of the generator on GX?
- Why are outputs divided into Output 1 and Output 2? Can we use 4 remotes on GX if we don’t use Spooky2 boost?
- Is using the Out1 port on the Boost 3.1 the same as using Out1 port on GenX directly?
- On one of my boost panels, the lights go on and off intermittently. How should I troubleshoot?
- Does it matter if I change my XM from connecting to a boost to Out1? Do I need to change the amplitude?
- Why is my MN port light lit when the boost is connected to the BN port?
- See all 39 articles
UDB1108S
- Is USB cable required for an UDB generator? Can the UDB connected to the PC without problems?
- Can UDB1108S run on Windows 8.1?
- UDB doesn't get detected. The driver is installed.
- Can you tell me what firmware number of UDB1108S? Are they the 4.2 that require the special Spooky software or the other standard ones?
- How do I upgrade my Spooky Remote v1.0 to Spooky Remote v1.1. Do you have instruction?
- Could the generator UDB1108S be used to make collodial silver and when the magnetic stirrer would be available?
- See all 14 articles
Spooky2 Colloidal Silver
- What is the purpose of the lozenge-type magnets in the Colloidal Silver kit?
- Can l set Colloidal Silver Maker to 20 ppm for cat’s respiratory issue?
- Can Spooky2 keep my pool water clean and safe?
- How can people test the PPM of the colloidal silver solutions made?
- To make colloidal silver, do I put one or two magnetic stirrers inside the glass container?
- Is that enough that the current coming out of the colloidal silver cord indicates 6 V. ?
- See all 93 articles
Spooky2 Glossary
Spooky2 & Hulda Clark Zapper
- For use "zapper" as defined by H. Clark, the device must be used with a direct current with a 0.25V offset. How is your Spooky 2-XM in "contact" mode (with the tubes) usable while it is powered by 220V?
- Doc Hulda's zapper is one of the best to remove viruses but the frequencies are slightly different with Spooky2.
- In reading Hulda Clark settings in the user guide. Could someone give an example of when to choose +100/+100 and when to choose +100/-100. Are they both called 100% offset?
- The Hulda Clark blueprint of the importance of the zapper being always at a positive offset, square wave and where the volt never goes down to zero regardless of frequency between 10 to 500000hz. How to do with Spooky2 that never reaches zero volt?
- Make Hulda Clark Zapper with Spooky2.
- The Hulda Clark presets is like the zapper? One frequency to kill all kinds of pathogens?
- See all 12 articles
Rife Machine
- Is Remote as powerful as Contact?
- Is there a difference between homeopathic solutions and Spooky2 Radionics?
- How should you place your generator?
- Can you use a Spooky2 as an ultrasonic machine?
- Does generator, computer, and Central have to be plugged into 3 separate outlets?
- Are Spooky2 machines safe for someone who has a gastric tube?
- See all 39 articles
Miscellaneous
- Is it more efficient to put DNA samples in holographic stickers instead of the usual ones for Remote treatment?
- Will it be harmful if I use the wrong program?
- What is the best mode to remove heavy metals from radiation poisoning?
- What does it mean to fix harmful carrier frequencies?
- What are your thoughts and findings on the "bad frequencies" that bring you some negative effects?
- Which is more effective? Physical vitamins, minerals, or Spooky2 frequencies?
- See all 1358 articles
Spooky2 Plasma
- Can I use copper braided cable sleeves for shielding on Plasma bulb wires?
- Is there any difference between running plasma with the GenX vs the XM?
- Can l use Spooky2 plasma ball anywhere on the body?
- Is there a difference between running Plasma treatment through Spooky2 Central with XM and GX?
- How many frequencies can the Spooky2 Plasma output at the same time?
- Is this normal for the one side of Plasma tube not to be lit all the way?
- See all 106 articles
Spooky G-scope
Spooky2 Sample Digitizer
- Can I use a wet paper towel to capture allergens in the air and deal with them by using the sample digitizer?
- Can we use a digitizer the same way we use a remote or is it only for biofeedback scans?
- If I clean the digital slides with alcohol, can I use them within my family?
- Why would one use the sample digitizer with nail filings over using remote with nail clippings?
- Are you happy with the Sample Digitizer results?
- What does a Spooky2 Sample Digitizer do?
- See all 49 articles