• After pulse-scan for minus (healing) frequencies, do l need to analyze the results for angle and angle + current or just to run them without analyzing?
• Is it recommended that you use pulse with USB hub?
• Why is the green light on Pulse visible but no BPM detected?
• Can you make the pulse sensor less sensitive?
• Is there any way to speed up the process of Pulse Scan?
• My biofeedback scan pulse spent long time, is that normal? Do I need to use the scan every day or can I keep using the same results for some day on and off?
• What can I do if the red light did not flash when I do Pulse Scan?
• Why does the Pulse Scan always loop?
• Why it warns me it is test mode when I use the Spooky Pulse Biofeedback?
• What's the best way to speed up a pulse scan?
• At what point is a raised BPM in grade scan considered significant (with XM generator)?
• How can I do muscle testing with Spooky2?
• Is it true that Pulse scan needs to hook the USB directly to the computer and not through a hub?
• If I want Spooky2 pulse to test for healing frequencies that GX can't pick up, what range would I use?
• Is there any use for Spooky2 Pulse if one has GX?
• I run the Cancer Biofeedback but the program runs for 15 minutes then shuts down. Isn't it suppose to run for an hour?
• How can l save Biofeedback Scan Results without losing all the info?
• My heartbeat is irregular and I’d like to perform a biofeedback scan with Pulse. It takes a long time before this scan will finish while the heartbeat is irregular. Is there a way to perform the scan so it won't take more than 2 hours before finishing?
• How long do you run a grade scan program on yourself for if doing two contact sessions a day? I have run another graded scan and the numbers have increased after 5 days? 
• Please can you advise what USB cable the pulse is - I need to buy a longer one. USB 2.0 A Male to Mini B 5 pin Data Cable Lead black 50cm, 1m, 1.8m, 3m, 5m Lengths (0.5m)
• Is it possible to scan from 0-1000hz?
• How can I know where I am weak or where to pay attention by reading the biofeedback frequency hits? 
• Can anyone tell me if it is possible to "Analyse" a biofeedback scan after it has been run and saved into programs? I can’t get the analyse button back. Do I need to plug in the Spooky Pulse again?
• I know that biofeedback scan can be done in contact and remote mode. What mode provides the best accurate results?
• Why would biofeedback scan frequencies jump all around instead of going in consecutive ascending order? I changed the max hits to 20, would that effect the single scan setting? 
• When I go to c:/Spooky2/Scans and open the BFB file for the graded scan I just ran, it has the headers but no information. I want to graph my results in Excel but there is no data. 
• I used to compare resulting scans to ave BPM. For example if I grade EBV and if none of the results are over my ave BPM, then I do not have EBV in my body. How do I know then if I have or do not have a specific pathogen with 0 ave BPM in Grade Scan?
• All about the 4 biofeedback modes and the two methods to do biofeedback with.
• How do I find the right program after scanning? The frequencies was very high like 93100 Where do I find the program to treat this?
• Does the new software increase the speed of the pulse based scans?