BIOFEEDBACK
- Can you perform a biofeedback scan with an XM while you have several remotes running healing/detox/support frequencies?
- Why did my reverse lookup only give me the frequencies but not the disease associated with the frequency?
- Should I stop BFB scan if I have a strong herx reaction?
- What is the best place to put the TENs pads to make a grade scan for candida?
- How do I get different scan results in a few hours?
- Will using a cellphone or tablet mess with the biofeedback scan? Will it affect the outcome?
- What do the frequencies means after a biofeedback scan? What should I do with them?
- Why my GeneratorX scan is going no-stop? How can I stop it?
- Will the scan results be influenced if one keeps coughing when doing a GeneratorX scan?
- How should I save Biofeedback scan results as a preset?
- What should I do when the Spooky2 Pulse is not detected?
- Do you need to change any setting from Contact to Remote for Biofeedback scan results?
- How can I know what is off balance or what pathogens are present in my body?
- How do I find out what the frequencies are after running biofeedback scan?
- Should you use more specific programs alongside biofeedback scan results?
- What the value (in parenthesis ) behind the hit frequencies means when one does biofeedback scans?
- Should you use more specific programs alongside biofeedback scan results?
- Do you have experience of progress from using Biofeedback on GeneratorX?
- How do I run a baseline scan?
- How can I filter the results of a grade scan made with GeneratorX?
- Why I get ressults even I didn't connect anything when doing a genx scan?
- How do you get the most accurate biofeedback results?
- What are the differences between remote and TENs pads when doing biofeedback scan?
- When running BFB scan resuilts through a kill shell, should the frequencies be displayed on the GeneratorX while the program is running? The lights are on on the boost.
- Can I run the Biofeedback scan results in contact mode all night or is that too much/long?
- What is the best way to do a biodeedback scan using baseline.
- Can I run two biofeedback scans on one GeneratorX and can I run 3 at the same time on one computer?
- All goes fine with the scan and then onto the kill, but after this it just keeps on killing without doing a rescan.
- I did a BIOFEEDBACK Scan on the Corona program, Do I use Kill or Heal with remote with those saved frequencies?
- How can you do a Biofeedback scan with baseline?
