Grade Scan questions

Q: I have a GX Pro
1) I want to do a grade scan for lymphatic programs. Do I always place the tens pads on my stomach when using the GX pro, or should I place them on my right wrist/left ankle to get the whole body lymphatic system?
2) I see that I should attach the tenspads-cable to the out1. Does it matter if it is the out1 directly on the generator, or can I also use the out1 on the boost? Are those two essentially the same?
3) I have previously run frequencies with tenspads and was zapped quite hard. I’m in a lot of pain and very tense from before, so don’t appreciate this. I then swapped to the colloidal port, which made it a little better. Can I do the same for a grade scan to avoid the zapping?

A:

1. For GenX, you want the distance between the TENS pads to be as small as possible while surrounding an area of interest on your body. In your case, try to put a lymph node between the 2 pads.

2. Use the Out 1 on the generator, removing the Spooky Boost.

3. It is low frequencies that cause pain. For Grade Scan, it is hard to avoid these low frequencies. I guess to make the scan less painful, I would use the Boost and the Colloidal Silver port. This is not optimal, but pain is not good either.