• Before my troubles started, I noticed that the square buttons (Channels) are pulsating.
• Do the Spikes hit at 9.5 and the rest of the time run at 2.375?
• In the main menu there is a facility to send emails, no mails are sent when I use this command.
• I'm tweaking different values in the Spooky2 software on my Spooky Central presets, but the value won't save to the desired preset.
• In the 160316 software upgrade I see a new box "swap frequencies + amplitudes for Out 1 and Out 2". It is ticked in all the Program Presets, including my older ones. Do I leave this box ticked all the time?
• Where is the reset button on the software?
• Whether the software developer would consider an android version of the spooky2 software?
• The graphs can show a cancellation but the remote leds light up using Spooky Boost.
• What is the maximum duty cycle of the XM generator? The actual maximum duty cycle that you can get is a little below 100%, correct?
• I do not know anything about unzipping, can you please help me install software?
• When I try to create a frequency program, I put some forward slashes in the Program Title, the software shows "Error In Database".
• When I press "Start" then Output section of window states that for OUT1 and OUT2, the Frequency is equal to zero (the same thing is shown on Spooky2 generator screen) during whole program. Is that something wrong with my configuration?
• How to move old Spooky2 database, settings, waveforms to new laptop?
• There is a problem with maximum frequency. I didn't realize this until today when I ran the following program. Note: max frequency set at 4,500,000 and present frequency on out 2 running at 6,850,030.
• I am not getting a minimum frequency since I installed the new software today. I have run 1v as amplitude for Lyme treatment as suggested by Dr. Stegmann's document. I see the 1v and the frequencies are in red, which is also something new.
• I'm using Spectrum to get rid of fleas. Since the fleas had ingested the blood of the stray cat, wouldn't I be running the killing sweep on the cat's DNA also? The cat was missing. Did I kill the cat?
• Dwell Multiplier for Morgellans Protocol is .35. Why not 1?
• Run a spectrum between 100kHz and 300 kHz. Set up a converge sweep from 100kHz to 200kHz but I alter the constant in out2=-out1+300 to 400. The reverse sweep then goes from 300 to 200. With multiple generators you could do most of the work in parallel?
• One of my channel buttons is enlarged and keeps on blinking.
• DUTY CYCLE only apply to square waves or can it be applied to other waveforms too?
• What's the difference between Wave Cycle Multiplier and Frequency Multiplier?
• When search "Lyme". The software shows "The following words in your search query were ignored because they are too common words: lyme."
• How do I get Spooky to add two sine waves? I tried putting one sine wave on each channel and looked at the result via the boost cable on my scope set to spectrum analyzer.
• How can I tell if a database set uses the boost output & syncs the waves?
• Is there any technical restriction on running a converged sweep on SC?
• We've been using KHZ and HC frequencies. Does it really matter to have Offset at 100% positive? Does the waveform really need to be Square?
• Out 2 = (out1 x is GRAYED out - Why?
• What exactly is the default program time for each frequency? I thought it is 180 seconds or 3 minutes. However, for Colloidal silver, the Dwell is 60 seconds.
• I wanted to run the Acne program shown in blue. How do I control the dwell for frequency 564?
• When using a frequencies set, how to know to set the time correctly in contact, in remote and in plasma mode: not to short and not too long?