- Can I generate colloidal gold using Spooky2?
- Why the two BPs for Bartonella change frequencies every time after load them?
- How to add programs into a preset?
- Why is the BFB graph running when I’m not running biofeedback scan?
- What to do if I fail to install Spooky2 software
- Why does the graph of my biofeedback scan goes back and forth between green and red?
- What’s the difference between GX Fast Biofeedback scan and General Biofeedback scan?
- How to add a program to the Morgellons&Lyme graded protocol?
- Do we run the same multipliers, harmonics in XM shell preset for GeneratorX?
- How to use Hunt & Kill on Spooky2 Scalar? How do I set generators?
- What parameters (number of turns, coil internal diameter, wire gauge) of a sensing coil should I use so that it does not distort the waveform? Could I use Spooky2 PEMF coil for this purpose?
- Could I use Eyesight To Improve (R) - JK with GeneratorX without changing the settings? Why is Wave Cycle Multiplier set to 3?
- Can Spooky2 software stop searching for generators after finding one (since I only have one)?
- Why is my "Disable Tooltips" function not working?
- Can I use Spooky2 Boost to increase the power of the GeneratorX scan and thereby hopefully increasing the sensitivity of the scanning sensor?
- Why Sleep Induction (R) – DB in Daily Wellness (R) – BY has a length of 6:31 hours, but in the Setting tab is set Schedule: Run for 5 Hours?
- How do I create my own program using only some of the biofeedback results?
- How to add presets to preset chain?
- Bell Palsy frequency programs should be run on Healing or Killing?
- How to run Multi-Vitamin and Mineral preset? Why does it freeze?
- Why doing a baseline before general scan my results are much lower than before just doing the BFB alone?
- Could the wavelength of the light be taken and out in as a frequency to Spooky2 software? (example would be the frequency of L305)
- Where is the chain editor in the new Spooky2 software (20190116)?
- How to amend/delete a custom program?
- Instead of running Terrain through Remote 24 hours a day, can we just run Contact 2 hours at a time?
- Is it possible to increase voltage over 20 volt when I'm killing pathogens in a Contact mode?
- Can I use the kill or heal (R) preset to run BFB results as well as Chakra programs?
- Must Biofeedback always be in killing preset?
- I would like to do a reverse lookup on a previous BFB scan. Is there a way to do that?
- What does Spooky2 software send? Frequencies?
Help Center
