- Where do I know that my generators are running? Will it make some noises? Why is it not flashing?
- Can I use the TENS pads and coil to treat cancer with carrier from spooky2 generator? Does it only work with Spooky2 Central?
- Troubleshooting: generators have no communication with software.
- What would happen to the generators when the main power goes off? What problems am I likely to have with generators being suddenly switched off & on?
- Can I can still use the bob beck blood electrifier when using the Spooky2?
- Can the generators still be running when the computer is off? How to keep the computer on?
- Why did Spooky2 recognize only one generator when I restarted two generators? All Spooky2 Remotes have indicator lights on for both generators.
- Is there a Freq gen for mac?
- How could my Vielight intranasal light therapy device be adapted to the Spooky XM generator? The model 810 runs with an 810nm LED at a 10Hz pulse (50% duty cycle) at 13 mW/cm2 power.
- What accessories can be connected directly to the generator?
- How to use Spooky2 Frequency Imprinting to make structured/activated/revitalised water?
- Do I need Multiplier if I want to place a organite pyramid on the PEMF coil attached to the generator with a Schumann frequency? Do I use the new output for the PEMF on boost 3.0?
- Why can't I see the generators in Spooky2 software when I use the splitter for 7 USB's?(One is working fine)
- Is output terminal 0V (GND) or High V or high Impedance when XM generator is not outputting signal?
- How many usb ports do I need for 2 pcs XM generators, 1 pcs Spooky2 Central and 1 pcs Spooky2 Pulse?
- Do I have to shut down the system and turn off all my generators and then log back in for sweeps when I use the original generators?
- Why does Spooky2 not save my settings anymore? All channels be changed when I restarted. (I have 4 XMs and 4UDBs)
- Can I run the same frequency on two generators?
- How to know your Spooky2 Generator is working okay?
- Has anyone used a Linear AM/ssb amp (driven by Spooky2 generator) with any success?
- What is the difference of those kits?
- Can I unplug USB cable while the program is on standby and plug it in to continue the program?
- What is the function of this bulb and can I use a cable without bulb for both XM and UDB generators?
- What's the cable on page 9 of the Users' Guide? What is that used for?
- What do I need for ultrasonic? How to use it?
- Why Spooky2 XM generator screen shows on when I turn on generator?
- Do I just manually inputting the frequency you want using a square wave when use PEMF Coil?
- Is the range of frequencies that can be covered the same regardless of their use with the remotes, contacts, or tube?
- Is it normal that the oscilloscope tests out 22V?
- Is the Spooky2 generator accurate as a standalone?
Help Center
