Hi everyone, I would like to run multiple presets but when I add more than one it picks the last in the list only. Is there a way to run multiple presets?

You have to create a chain preset—Spooky2 won’t run multiple presets unless they are saved as a single chain.

Pick the preset you want and add it. Then click on ‘Programs’ and add each one you want to include in the chain. Once you have all you want, save them all as one preset. Just make sure that when you create a chain, you are using the same mode (all Plasma, all Remote, or all Contact)—don’t mix and match. Your saved chain will show up under the Preset tab, under the ‘person’ icon (next to the house icon).

To test that your chain is working:

Go to the Control tab. Enter 3000 in the Age Factor field (below the frequency box). Tick ‘Overwrite Generator’ and select VG (Virtual Generator). Click Start.
This will run your chain in super fast mode so you can see each preset load in sequence.
Once tested, click Stop, set Age Factor back to 1, select your real generator, and click Start again to run it normally.

Important: Do not run Age Factor 3000 on yourself—it’s just for testing the chain.”

If you’re unable to load presets into the chain, make sure your generator is connected. Some users found that chain creation may not work properly unless the generator is powered on and connected to the computer.

Source: https://www.facebook.com/groups/spooky2/posts/3104125909749291/