I am trying to run the Protomxzoa Sweep and the instructions are not matching the changes in spooky. Out 2=Out 1x1+0 volt. The x1 is missing with the software changes. How do I now get the correct settings.

So to get this setup correctly, here is what you can do:

1. Start with the JW - Healing (Contact/Remote) preset.
2. Set the waveform for Column 2 to Follow Out 1 instead of Inverse+Sync.
3. Set the X parameter to 23 on the same line as the square waveform which is currently ticked on Column 1.
4. Set the Spectrum % also on the same line as the square wave to .579.
5. Set Out 2 = (Out 1 x -1) + 1036 - [unchecked] Hz. which will no longer be greyed out due to step 2 in this list.
6. Set Out 2 = (Out 1 x 1) Volts is already setup for you, but please verify.

Then you will be all set to go. Load the frequency set Protomyxzoa Rheumatica Sweep, and optionally save it as a preset so you don't have to set it up from scratch in the future.

For more details, please check:
https://www.facebook.com/groups/spooky2/permalink/573377122824195/