This indicates that the biofeedback was performed in "emulation" mode. This mode is enabled whenever Spooky2 Pulse is not detected by Spooky2. Go into the Advanced Menu and view the connected devices. You should see Spooky2 Pulse listed before your generators. If not, you may need to check your Spooky2 Pulse cables and restart Spooky2.
Articles in this section
- After pulse-scan for minus (healing) frequencies, do l need to analyze the results for angle and angle + current or just to run them without analyzing?
- Is it recommended that you use pulse with USB hub?
- Why is the green light on Pulse visible but no BPM detected?
- Can you make the pulse sensor less sensitive?
- Is there any way to speed up the process of Pulse Scan?
- My biofeedback scan pulse spent long time, is that normal? Do I need to use the scan every day or can I keep using the same results for some day on and off?
- What can I do if the red light did not flash when I do Pulse Scan?
- Why does the Pulse Scan always loop?
- Why it warns me it is test mode when I use the Spooky Pulse Biofeedback?
- What's the best way to speed up a pulse scan?
Our Blog
Get the latest news and updates first
Our helpline hours:
9 AM – 6PM UTC+8, Monday – Friday
Video Guides
Learn how to use Spooky2 with our short, step-by-step video guides
Comments
Please sign in to leave a comment.