• The scope is attached to either cylinder and I get the muscle vibration at 1 KHz but with no scope attached I can't feel anything so what is going on?
• Has anyone here used the contact mode on acupressure or acupuncture points. If so, any result to share?
• What you can do when you experience shocks in contact mode?
• Is Contact Mode Doing Scalar Wave in the Body? In contact mode you have the Inverse+Sync option. This seems in fact producing an electrical wave that is the opposite on OUT2. When the 2 waves meet in the middle of your body scalar energy will be produce.
• I'm going to start the 4 generator cancer protocol for prostate cancer. Where should I place the tens pads for the contact method?
• Is it ok if I wear metal rings on my fingers during contact session using hand cylinders?
• What if the chair is steel during contact session using hand cylinders?
• What is the recommended way of holding the hand cylinders?
• Can I use computer during contact treatment using hand cylinders?
• So how should I place my both hands during contact treatment using hand cylinders, can I put both of them on the table?
• If one hand was touching the face during contact session using hand cylinders, is that ok?
• If both hands touch the leg during contact session using hand cylinders, is that ok?
• Can 2 hands touch each other during contact session using hand cylinders?
• Would love some clarification on Tens pads placement during a BFB scan?
• Is it possible to use 2 generators for 2 contacts use at the same time? Can I use one on a treatment setting and one on a detox/healing setting at the same time but both on the TENS pads? (So I'd be using 4 pads attached to the body).
• Can you use a longer cable for contact mode like a double extension? Will it degrade the signal strength? If so, what's the maximum length?
• I ran the frequencies produced by the scan and didn't feel any current for a while, even though the amplitude was set for 20.
• Spooky2 Contact Mode Spooky Hand Cylinder and Spooky Tens Pad Instructions.
• When using the tens pads, the wire color doesn't coordinate with placement right?
• Since the colloidal silver output limits the signal strength, am I getting any treatment through the colloidal output? Can I plugged the tens cable to out1?
• If I want to work with 2 sets of tens pads, or hand cylinders and foot plates, is this how I would hook up to the generator with the boost?
• How many times I can reuse TENS pads? Can the TENS pads be reused?
• Contact Mode Set-Up For Hands And Feet - Outputs OUT1 & OUT2.
• If there is maximum cable length which can be used for TENS in Biofeedback scans and occasionally as an extension for TENS and Tubes during treatments. I just want to make my own (I know it is 50 ohms coaxial), little bit longer.
• Does contact current penetrate deep inside the body?
• Where to place TENS Pads?
• I have 2 generators running 2 different things simultaneously - how do the 2 different programs get to the hand wands or Tens pads at the same time? Do I have to hold the wands and have tens hooked up?
• If I connect one red alligator clip to a metallic rod, connect the black alligator clip to the other end of the same metallic rod with a clear continuity between them (in contact mode). Would that cause a short in the generator?
• Are the hand cylinders chrome plated?
• Using Contact Mode, I have a set up with one foot plate and want to clip on only one of the electrode cables (not both). Which one would I use, red one? Why are the cables red and black? Different polarity?