Spooky2
Articles
-
What are the buttons for on the generator?
All buttons including the dial knob are for testing. One never needs to touch the buttons on the generator. All run through software.
-
What is Biofeedback and how does it work?
When the body encounters stress, it alters its electrical fields through the autonomic nervous system. The results are changes in skin conductivity and heart rate.Telling lies to someone creates st...
-
Why Spooky2 software says 'Emulating Spooky2 Pulse.'?
Yes. The graph panes are all linked to each other, and will only show real data if the pulse unit was plugged in prior to starting Spooky2 and you are wearing the sensor.In the absence of the pulse...
-
Is it common for the biofeedback scan to run longer than the suggested 88mins when single scan is ticked?
Yes, the speed of the scan is greatly influenced by your resting heart rate. I believe the estimated scan time is based on a resting heart rate of about 70, so if your resting rate is lower, the sc...
-
"Planet - Uranus (Octal #13)" What does that mean in a biofeedback scan?
It probably means that the frequency you got back is doing something for which there is no label to attach. The frequency when divided in half 13 times is close enough to 207.36 Hz that the reverse...
-
Can one perform a Biofeedback scan using Spooky2 Central or Plasma?
It is recommended not to use plasma for this. For more details, please check:https://www.facebook.com/groups/spooky2/permalink/626975604131013/
-
Where do the ear and finger clip attach to?
This short answer is that you use the generator and either a remote or contact to transmit the frequencies to your body, and the pulse heart rate monitor to send the feedback on how your body respo...
-
Why No Spooky Pulse Detected - Spooky2 Pulse was not detected on your system. Results will be invalid and not saved?
Couple things to check:1. Plug directly into a computer port if you are using a hub. Hubs add latency which is an issue for the pulse. 2. Ensure that it was plugged in before starting Spooky2 and t...
-
Why "Data Error" comes up and my biofeedback scan stalls for a few seconds then continues and the permanently stalls?
Spooky2 Biofeedback determines the body’s response to applied frequencies. At times these frequencies interfere with the sensitive electronics built into Spooky2 Pulse. Spooky2 can filter out most ...
-
How do I set the Spooky2 machine to run remotely and non stop?
Connect a Remote to the generator for remote operations, and to run non-stop use Repeat Sequence = 0. For more details, please check:https://www.facebook.com/groups/spooky2/permalink/534456506716257/