How do I use only electricity with XM or GX? I just want to run electricity through my hand using the pads with no generated frequency.

Spooky2

Updated February 19, 2019 08:44

1. Waveform Settings: DC (== Direct Current)

2. Maybe you could set Offset=100 in Settings tab. Set Amplitude of OUT1=5 (Volts). Connect electrodes to OUT1 without Boost.
If you set Amplitude higher than 5V, you do so at your own risk for constant DC voltage. Momentary contact with higher DC voltages has less risk.

One thing to consider is the order in which you pick up and release each electrode and what polarity is on each electrode.
Read post #2 for more information: https://www.spooky2.com/forums/viewtopic.php?f=28&t=2808&p=27356&hilit=joe+cell#p27356

For more details, please check the link from:
https://www.spooky2.com/forums/viewtopic.php?f=5&t=10564