Spooky2 Support
Spooky2 Rife System
Spooky2 Software (20160803 and above)

Can spooky2 go at 0.25 volts up. Parasites can be killed with a very low voltage. The picture of the Zapper output on an oscilloscope illustrates the varied square wave voltage which stops at 0.25 Volt and therefore does not go below the 0 volt.

Spooky2

October 07, 2016 06:14

You can use a waveform with a 100% offset inside, as MM_ModSquare, and add an offset of 5% to Out1. With this setting, the amplitude will be always positive, and never negative.

I attach a screenshot with the parameters you have to set.
1.- You have to set a 5% offset.
2.- You have to select the waveform.
3.- You have to select Inverse+sync.