Why doesn't the generator show any signs of operating? No switching on, no display, just "dead". At the time of failure it was powered by an external 5V switch mode plug type power supply and connected to a SPA4 controller board (Input B).

I have talked to the engineer, and they said that the internal power supply of your generator must have failed. They are not familiar with the SPA4, but said that perhaps an excessive earth current loop caused the problem. The SPA4 has no protective opto isolator, and plasma tubes can induce very high voltages in nearby conductors.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.

Articles in this section

See more
Our Blog
Get the latest news and updates first
Our helpline hours:
9 AM – 6PM UTC+8, Monday – Friday
Video Guides
Learn how to use Spooky2 with our short, step-by-step video guides