Can anyone please tell me the difference (if any) between Hunt & Kill and Scan & Run?

1. The Scan & Run preset starts with a BFB scan and then runs the scan results automatically on an allocated generator. After the program of scan results is completed, another full biofeedback scan commences. This cycle repeats until the preset is stopped, or no hits are detected, indicating the pathogens in your body have been removed.
The Hunt & Kill preset begins with a short biofeedback scan. The hits are then run on an allocated generator. In the subsequent scan/run cycles, the previous hits are re-analyzed. Pathogens that are mutated are found and hit again. It does not matter how far the pathogens run. They will be found. And they will become targets. This preset keeps refining the first scan results and runs automatically until it is manually stopped or no hits are detected.

For more information, please check this blog: https://www.spooky2-mall.com/blog/scan-and-run-preset-vs-hunt-and-kill-preset/

2. Between the two, scan and run seems to tackle more pathogens but not as well as it is doing a fresh scan of the body and will pick up whatever seems to be predominant at that time.. Hunt and kill kinds dogmatically find the first top frequencies and doggedly attack the same ones with slight variations to get more accurate numbers for each pass through the top frequencies. So you have to decide if you want to do some damage to more types of organisms or to really screw over the ones that it picked up with the first scan.

For more details, please check the link:

https://www.facebook.com/groups/spooky2/posts/2540268946134993/