I will like to run a Hulda Clark Zapper - Remote. There is for example this program "Clark 30KHz Zapper Remote". I can’t trust myself to create this wave setting myself with all the parameters. Can somebody have a preset file for that?

Spooky2

April 26, 2017 03:09

If you see the database line for that program, you'll discover that all the necessary parameters are already set.

W9 is the waveform to be used, A9.5 is the amplitude, O=100 is the offset. These parameters will override the ones you could have set previously, so no need for you to set anything.

So you have only to select it, go to the Control Tab, select your generator (after marking Allow Channel Overwrites), and hit Start.
If you want the 9.5V setting, then don't use the Boost. Connect the remote directly to Out1.

Be aware that the program for remote mode has a Dwell time of 17 hours, but it will run continuously until you stop it manually.

For more details, please check the link:
http://www.spooky2.com/forums/viewtopic.php?f=5&t=7674

I will like to run a Hulda Clark Zapper - Remote. There is for example this program "Clark 30KHz Zapper Remote". I can’t trust myself to create this wave setting myself with all the parameters. Can somebody have a preset file for that?

Comments

Articles in this section