Spooky2
Articles
-
Is it beneficial to change the duty cycle from the standard 50% to 93%?
Changing the duty cycle alters the harmonics that are created by the generator. A duty cycle of, say, 93% will reduce the power of many harmonics. As with any leading-edge system, it is best to exp...
-
What’s the difference between a Spooky Spectrum Sweep and a Spooky Converge Sweep? What do they each do?
A Spectrum Sweep outputs multiple simultaneous frequencies by generating a sweep on each output. The sweep on Out 1 ascends from 0Hz to 3.2MHz, and the one on Out 2 proceeds from 0Hz to 800,000Hz. ...
-
Why can't we see the graphics change when altering the Duty Cycle?
Only square waves can have a duty cycle other than 50%. This is a law of physics, not a Spooky2 limitation. The duty cycle is shown in the waveform graphics for square waves.
-
What is Phase Angle and how can it be used (healing, detox, pathogens)?
The phase angle is the angular difference between the signals of the outputs of the generator. The function is used mainly to produce a special signal pattern from the outputs when they are running...
-
Does inverted sawtooth have similar harmonics to square waves? And why has someone said that with inverted sawtooth the Duty Cycle must be set at 49%?
Inverted sawtooth waves use every harmonic (refer to "Harmonics” in the Glossary) but square waves only use odd harmonics. The duty cycle setting is only necessary for the older UDB generator and i...
-
Is there a limit to the amount of scalar power and to the voltage of Remote mode?
Applying 20 volts to a Spooky Remote will produce no adverse effects. The scalar wave generation is more efficient but the strength of the changing magnetic field is still low. We are unsure of th...
-
Is using a voltage setting as low as 1 or 2 volts too low for the Rife machine?
It is too low if you wish to use Contact Mode with electrodes, which requires a setting of 14-20 volts for cell penetration. But it’s fine for Remote Mode because you only need to penetrate the fin...
-
Why can’t I change my Repeat settings in Spooky2?
Settings cannot be altered in Spooky2 if the colored Channel Control Panel is open, or if a program is actually running. You should always enter the settings you desire before clicking the red butt...
-
Is there any way not to re-search for and reload my frequency sets every time l turn Spooky2 on?
Spooky2 remembers all your settings and the frequencies that you used the last time you ran it. So there’s no need to search and reload - simply click the red Channel button and you’ll see all your...
-
Why does my computer still shut down after setting it never to sleep or shut down?
It's not possible for Spooky2 to instruct your PC to shut down - it has no commands for this. Set Windows Update not to download and install updates. Keep the laptop plugged in always, and set it n...