Spooky2
Articles
-
Can I have a Remote BN and a Remote MN on the same boost?
1. For Boost 2.0: It is not recommended to have both plugged in at this time. However, there are those that are experimenting with just that configuration. Be aware that when you plug more than one...
-
What is the lowest voltage setting while using Remote?
Maximum amplitude: +- 20 voltsMinimum amplitude: +- 1.8 voltsOptimum amplitude: +- 4.5 voltsMinimum Frequency: 0 Hz (DC)Maximum Frequency: 20 MHz (greater with a low impedance source)Solder type: L...
-
How long to run the program Immune System Stimulation PROV with Remote?
The recommendation of five runs is for Contact mode. The safest way to translate that into Remote mode time is to multiply by 20, which gives you 100. Each one runs for 112 minutes when used with a...
-
My generator on the killing mode sounds like it's working, but the screen went blank. Is this normal or is it broken?
I once had one of my generator's displays go a bit out of whack, not all bright like yours, but part of the screen was a different brightness. I had to shut down spooky2, power off the generator, ...
-
What do I still need when I've had a starter's kit?
A XM generator, a Spooky boost, and a BN are enough. If you want to use for two people at the same time, you can also buy another pair of hand cylinder. You can also get a pair of silver rods if yo...
-
What does preset mean?
A preset is what we save but can be one of two things:1.The settings to be used in a program without any frequency sets. JW - Healing is an example, which we call Shell Presets. 2. The settings to ...
-
What is the difference between "repeat each set" and "repeat each program"?
Each entry in the database is considered a frequency set. All frequency sets to be ran, plus the settings (waveform, etc.) is considered a program. When you run a program it must play each freque...
-
Is there any way to remove the "Instructions" section from the Spooky2 software window? How to make the Customize page become my default spooky software page upon loading.
In order for you to save the screen with Customize ticked, make sure to go to "File" menu and click "Save as Startup Default". Be aware that also the waveforms and other settings that were selected...
-
Are we able to bypass the "look for more generators?" step when loading spooky?
Be sure to check in the Advanced menu if you have or not a value in the DDS Generators field, other than "0". That might be the cause of not looking for other generators, because a value other than...
-
Why could it be that I can’t set the repeat each set to 0 ?
Repeat each set requires a setting of 1 or greater. Repeat Program is the only setting I know that uses 0 to indicate repeat forever. For more details, Please check:https://www.facebook.com/groups...