Does G2=generator 4 in the software and G1=generator 5? Also why do you not use spooky boost with a Biofeedback?

1. If you look at the display of your generatorX, it tells you the generator number it has in the spooky software.

2. As far as I know, spooky boost provides voltage boost, and at the same time could be more susceptible to tiny spikes (your hand touching tens pad etc). Hence to avoid this, it is suggested not to use boost while BFB. Out1 and OUT2 are out of phase to each other(default). So perhaps you could run killing on OUT1 and at the same time run remote mode killing on OUT2 (check this with others too).

3. The Spooky2 software does not assign the port numbers ... Windows does this. I make life a little easier for myself by putting notes on ours, but that's probably not necessary if you're only running the two gens.

4.The Boost is removed during a biofeedback scan to reduce the amount of "noise" and thus give you a more accurate result.

For more details, please check the link:
https://www.facebook.com/groups/spooky2/permalink/1566845010144063/