1. For the Spooky2 XM only. Add your appropriate Frequency sensor, a preamp, with Amplitude of signal input should be larger than 1.5V. And a Maximum voltage input of 20V.
Frequency meter function:
A Frequency counter which can measure various parameters of the external input signal such as frequency, period, duty cycle, positive pulse width, and negative pulse width.
Enable the Counter
Press the MEAS button of the front panel to enable the counter and measurement Manu. External signals for measurement can be inputted by EXT.IN connector and the result will be displayed on the screen in real-time. The lowest frequency of workable is 0.01 Hz. (GATE TIME: 100S)
Press the COUN button to enter the external pulse counter function. At this time COUN button is turned into the FREQ button. Repeat pressing this button to switch between FREQ and COUN.
Frequency Meter/Counter Interface
When the Frequency Meter/Counter is turned on, press STOP button to pause and press ZERO button to reset.
2. If the substance can be powdered and put into a solution of distilled water, you can use the Sample Digitizer to find its frequency. To do this though, you need an EMF quiet room, which is essentially a Faraday cage, and you may need to buy some silver fabric used in EMF protection. See this post in the Spooky2 forum: https://www.spooky2.com/forums/viewtopic.php?f=12&t=11200&p=115638&fbclid
For more details, please check the link:
https://www.facebook.com/groups/spooky2/permalink/1454381378057094/
Comments
It would be good to have a video on this.
Please sign in to leave a comment.