Why do the raw phase angle (VI Phase) and the raw current readings (Current) from the Generator in the Control Tab is only shown for Out 1 and not for Out 2?

Articles in this section

• How many programs can I load into GX Pro at once?
• What's the difference between GX and GX Pro?
• Can the generatorx run remote at the same time as contact treatment? I haven't got that right yet?
• what's the difference between XM Generator and GX Pro? Can XM run high frequencies?
• Why does GenX display occasionally flicker/dim rapidly once in a while?
• Can I run Plasma on G1 and sync contact mode on G2?
• Does the GX need to be cleared or reset after each use?
• Why can’t l load Daily Wellness onto my GX?
• Why do OUT1 and OUT2 of the same port show 2 different frequencies?
• Is there a little red fork-looking thing in the corner, how do l fix it?