In the guide it says to use two red cables if you do not have the Spooky boost 2.0. So if I use two alligator clips from out 1 and out 2 do I change the settings from inverse sync to follow out 1?

Articles in this section

• For different modes, which Spooky2 Boost port to use? And how about biofeedback scans?
• How many remotes can I attach to the boost?
• Is BN port on Spooky2 Boost just a straight extension of BN port of the generator on GX?
• Why are outputs divided into Output 1 and Output 2? Can we use 4 remotes on GX if we don’t use Spooky2 boost?
• Is using the Out1 port on the Boost 3.1 the same as using Out1 port on GenX directly?
• On one of my boost panels, the lights go on and off intermittently. How should I troubleshoot?
• Does it matter if I change my XM from connecting to a boost to Out1? Do I need to change the amplitude?
• Why is my MN port light lit when the boost is connected to the BN port?
• Can you connect multiple devices to a same boost?
• Can you use Spooky2 without the boost?