I can't feel any thing from the hand held tubes even when 20v applied in custom mode cable connected to boost 2 using colloidal centre connection.

Contact mode causes a tingle with low frequencies, but you will not feel anything when the frequencies are high enough.

Test with a sine wave frequency lower than 1000 Hz. "Backache 2" is a good example. Set the Frequency Limits boxes to zero. Uncheck the "Reduce amplitude < 10 KHz" check box. Set the amplitude to 10 volts. When you run the program, you should feel something between a slight tingle and a jolt. Adjust the amplitude up or down as desired. 

Once you know that contact mode is working, you can use any frequencies that you want. It's a good idea to check the "Reduce amplitude < 10 KHz" checkbox for contact mode.

For more details, please check:
http://www.spooky2.com/forums/viewtopic.php?f=67&t=4248

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.

Articles in this section

See more
Our Blog
Get the latest news and updates first
Our helpline hours:
9 AM – 6PM UTC+8, Monday – Friday
Video Guides
Learn how to use Spooky2 with our short, step-by-step video guides