If you are using the CS preset how can you then influence the speed of the manufacturing process? It says that the position of the black knob (the stirring speed) on the magnetic stirrer is not important?

Articles in this section

• What is the purpose of the lozenge-type magnets in the Colloidal Silver kit?
• Can l set Colloidal Silver Maker to 20 ppm for cat’s respiratory issue?
• Can Spooky2 keep my pool water clean and safe?
• How can people test the PPM of the colloidal silver solutions made?
• To make colloidal silver, do I put one or two magnetic stirrers inside the glass container?
• Is that enough that the current coming out of the colloidal silver cord indicates 6 V. ?
• If I use the colloidal silver port (due to shocks from the high power port), do I also need to untick the option "reduce amplitude < 10kHz" ?
• How do you clean the silver rods?
• Why is there no line when I shine the laser light to my colloidal silver batch?
• How can I run 50 hours to make colloidal silver?