Spooky2
Articles
-
How to apply the BXBY frequency set of 7829.37.42 using Plasma mode
The BXBY waveform did not meet expectations and has been discontinued. Please use the JW - Spooky Central Cancer presets instead.
-
I can't feel any thing from the hand held tubes even when 20v applied in custom mode cable connected to boost 2 using colloidal centre connection.
Contact mode causes a tingle with low frequencies, but you will not feel anything when the frequencies are high enough. Test with a sine wave frequency lower than 1000 Hz. "Backache 2" is a good ex...
-
Why can't I hear the ultrasonic speaker when I run the generator at 3000 Hz?
The ultrasonic speaker runs at a lower frequency than the generator input. The input frequency is divided by 16 for high-speed operation and 256 for low-speed operation. At high-speed setting input...
-
How do we determine the amplitude when using contact mode and what does that mean?
Contact needs enough voltage to penetrate the skin in order for it to penetrate through the body. The recommendation is between 14-20v. Enable reduce amplitude < 10 kHz so that in the case of low ...
-
When using the hand cylinders or pads for killing, what amplitude is recommended, how long should each session be, and do I use: Follow out 1, spike+sync, or Inverse + sync? What are some of you using?
When using the hand cylinders, it is recommended that the voltage be between 14 - 20v to properly penetrate the body. With that said, low frequencies will be readily felt and so it is advised to al...
-
What is the maximum time I can use the plasma continuously?
There is no maximum time. Plasma is best suited for short-term treatment, but if necessary, you can choose the corresponding program to run according to your disease, and it can also be used overni...
-
I received Spooky Boost v2.0 and did the setup. Remote mode working great, but contact mode not working when connected to spooky 2 boost colloidal input.
Spooky Boost v2 has a Colloidal Silver output with a current limiting resistor. This output is also suitable for safe contact mode treatments. Research has found that less than one milliamp is the ...
-
Can I set up Spooky2 Central in an open area?
Spooky2 Central can be safely used in almost every room, except rooms that are damp such as the bathroom or laundry. Sparks will not jump from nearby metal objects. The bedroom is an ideal place to...
-
Can people with pacemakers and metal vascular clips use Spooky2 Central?
Most vascular clips are ok for use with MRI scanners that are much more powerful than Spooky2 Central's coil output since they are made from metals or materials that are not magnetic. Some clips ar...
-
What are the gauss rating and Hz range of the PEMF coils?
The coil output of Spooky2 Central is a short spike as opposed to long duration signals, so it cannot be compared to other systems. Our unit is 200 gauss, but the field strength may be higher. Spoo...