Why do OUT1 and OUT2 of the same port show 2 different frequencies?

Articles in this section

• Why does GenX display occasionally flicker/dim rapidly once in a while?
• Can I run Plasma on G1 and sync contact mode on G2?
• Does the GX need to be cleared or reset after each use?
• Why can’t l load Daily Wellness onto my GX?
• Why do OUT1 and OUT2 of the same port show 2 different frequencies?
• Is there a little red fork-looking thing in the corner, how do l fix it?
• The lights on GX are too bright at night, is there a way to turn it off?
• How to resume my treatment when the generator’s power accidentally gets cut off?
• If GeneratorX has generator 1 being port 3 and generator 2 being port 4, where are port 1 and port 2?
• What should I do if my GenX isn't being picked up suddenly by my software?