Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

Is it correct that the scalar digitizer master and slave frequencies run at 0V?

Scalar Digitizer Master runs at 0V due to this statement in the Notes describing how it works - "G1 will start the biofeedback, but no frequencies will be produced. Instead, the amount of scalar energy being absorbed for each frequency by the body will be recorded."
The Slave runs at 5V per the Settings tab.

 

For more details, please check the link:
https://www.facebook.com/groups/spooky2/posts/2091067621055130/

 

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.