Troubleshooting: why does my Spooky2 software says it's not responding? I accidentally pressed a button on the generator.

Couple of points:

The screen shot shows a generator that has been freshly turned on. It defaults to the sine wave.

A power cycle resets the generator back to factory.

The reset button on the generator control panel resets the factory reset parameters in case you overwrite it messing with the generator's built in buttons.

Once Spooky2 has started and made contact with the generator, the waveform on the display will change from Sine to Arbitrary.

If it does not change on startup, Spooky2 did not see the generator.

Ensure you check the # of generators to find in the Settings tab if you have ruled out cables.

For more details, please check the link:

Was this article helpful?
0 out of 0 found this helpful



Please sign in to leave a comment.

Articles in this section

See more
Our Blog
Get the latest news and updates first
Our helpline hours:
9 AM – 6PM UTC+8, Monday – Friday
Video Guides
Learn how to use Spooky2 with our short, step-by-step video guides