Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

Troubleshooting: why does the generator screen blank out when using the PEMF Coil on 20V amplitude?

There is indeed a problem when using low frequencies. I have switched back to the June 5 2016 software and used boost 3. The program I am using had the duty cycle changing but this has not happened even with June software. When I used the Boost 2 the generator went black but when I wiggled the cable it would light up, so I put a plastic bottle cap under the BNC and it worked. I later changed it to Boost 3 and it is working but duty does not change at all and the dwell of 120 was shortened to 100. At least It was able to run those frequencies with plain settings.

For more details, please check the link:
http://www.spooky2.com/forums/viewtopic.php?f=6&t=6097

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.