Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

I'm currently doing a detox session where out 2 is the inverted saw tooth and is connected to remote BN. The out 1 is the inverse and sync and is connected to remote MN. Each of these signals are different and won't be canceling each other. Right?

Inverse + sync is under the Out 2 column. In this column, you only select One item. So either you choose a waveform or choose inverse + sync, but not both. You can experiment and try clicking a waveform and inverse + sync, and you will see that the mark on the waveform would disengage.

You may use different waveforms for Outs 1 and 2 simultaneously with one remote on each Out. No need for use of inverse+sync. If you choose your waveform from the dropdown menu, and invert a waveform under the "I" column, they will be combined as you will see on the third window of the waveform display. What you lose without the Inverse + sync, is the doubling of the amplitude. As the User's Guide indicated, remote will still be effective with a low amplitude, you may read it from page 49 of the Guide:

If you decide to use a boost cable, and use Follow Out 1, then you will have cancellation if you do not alter Out 2. This can be done as follows: Click on Follow Out 1. This will give you access to Out 2 Controls where F2=F1 x 1+ .01Hz (Scoon effect) or F2=F1 x 11 + 0Hz.

I notice you are experimenting with the BN and MN use at the same time. You may take a look at this thread where experimenters show how they use it. See the screenshots at:
http://spooky2.com/forums/viewtopic.php?f=9&t=1713&hilit=%2ABN+and+MN%2A+BN+MN+Remotes&start=30

To be honest with you, I use a no fail setting most of the time with Offset of 100% and -100% with boost cable and inverse sync. My amplitude is between 5 and 10 as the boost will double it. This is depending on the waveform I use (some are given ready to be used with no additional settings to be made).

For more details, please check the link:
http://www.spooky2.com/forums/viewtopic.php?f=83&t=5484

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.