Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

I noticed that I could not get the NEG (-) LED to light on Channel 1. But Ch. 2 worked fine. I connected my PC Scope and saw that Ch. 1 does not go negative like Ch. 2 does when I set the OFFSET to 0%.

This I can not be sure of the reason, and it should not be the case. Also, if you got 40v peak to peak in your other test below, Out 1 has to be working correctly in order to achieve this result. Suspect that for whatever reason, when you conducted your test, an offset was still in effect. It could be that the command to reset the offset did not make it the generator at the time you ran the test. Look for errors being reported in Utils, Show Errors and Warnings.

It could also be attributed to using a waveform that has a positive offset encoded into itself.

For more details, please check the link:

Have more questions? Submit a request


Please sign in to leave a comment.