Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

Do I just manually inputting the frequency you want using a square wave when use PEMF Coil?

Yes, you can run a frequency set, a single frequency of choice, etc...

There is a shell preset for PEMF Coil in Presets tab.

Also, operation would be not much different than when using Spooky2 to drive a remote.

One can even just use the JW - Healing (Remote) preset and change the amplitude to 20. Then load frequencies of choice and stop when done.

If you have a particular frequency in mind, you can crate a custom frequency set to load. Use the File, Create Frequency Set to do this. The August software and above has Spooky Coil (XM Direct) - JW preset, you can directly use it.

To use the PEFM coil, either plug it directly into Out 1, or use a barrel connector to attach to the MN or BN port of the Boost 2.0.

Do not use the CS port.

If you have a boost 1.0 cable, you can forgo the barrel connector.
Use a square wave to start, either with or without offsets.

Please check this blog:
How to Connect PEMF Coil to the XM Generator
http://www.spooky2-mall.com/blog/connecting-pemf-coil-to-the-xm-generator/

Choice of frequency is up to you. Anywhere from .00001 Hz to 20 MHz.


For more details, please check:
https://www.facebook.com/groups/spooky2/permalink/588240698004504/

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.