Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

I see there are 2 channels running. "Out 1" (Square H-Bomb) and "Out 2" (Inverse+Sync) are different in the software green box and also directly on the LED display of the generator. I only got 1 magnet connected. What is happening with CH2?

That is no problem - you have it set up correctly for the terrain protocol.

Detail:
The Boost unit combines the Out1 and Out2 of a generator into both the BN and MN output. Since you have a BN remote you have attached it to the BN output correctly.
In normal cases you only have one magnet remote connected to the Boost at any one time.

FYI: There is a slight mix-up with terminology with the word "channel".
1) In the Spooky2 software a Channel (PINK BUTTON) refers to an XM generator (which in turn has TTL_IO, Ext.In, Out1, Out2 BNC connections); (Then with boost Out1 and Out2 are then combined into a single output called BN)

2) On the face-plate of the XM generator it reads "2 Channel Signal Generator".
To make life simpler; disregard the use of the word Channel on the generator face-plate (2); and just think of it as having two outputs.

For more details, please check the link:
http://www.spooky2.com/forums/viewtopic.php?f=9&t=4934

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.