Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

I'm using the Spooky Boost 2.0. Do I still need the boost cable to produce the Scoon effect? I write only: Out2 = (Out1*1) + 0.1?

The Scoon effect is based on the fact that when you mix two frequencies just a little bit different, you get a beating result, that produces a sweep in the Duty Cycle of the resulting waveform.

You can receive this effect via Remote mode if you use a boost cable (or boost 2.0) to mix the two Outputs, or if you use two remotes, one in each Out.

Same thing with contact mode. You can mix the two signals with the Boost cable, or you can use two pairs of tens pads or electrodes from the two Outs.
Whatever method you prefer, it has to use the two Outs.

For more details, please check the link:
http://www.spooky2.com/forums/viewtopic.php?f=39&t=5314

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.