Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

Spooky information say colloidal silver could be clear or a slight yellow in colour. How can I tell that my colloidal silver worked for consumption if the water is still clear?

Here's my .02. I've been making Colloidal Silver with Spooky for a few months now. I've done a lot of trial and error to get the laser to have a nice defined beam through the water and not have the rods get too black. I've made about 20 successful batches of CS with this approach:

I posted this on the Facebook page as well a while back.
I use a 500ml beaker on the electronic stirrer.
I get the rods as far apart as I can in the beaker.
The rods are rather long, so I have curled the ends into a spiral shape so you get as much silver in the water as possible. Like looking at a Sea Horse's tail.
I changed two settings in the Spooky, Program Options Dialogue Box:
Dwell changed from 60 to 1400 (That's 1400 minutes, that's just shy of one full day)
I changed Swap Waveform from 300 to 500. (this does a good job keeping the rods from depositing black particles into the water)
I set it and forget it until the next day where I will do the same for the next batch.

For more details, please check the link:
http://www.spooky2.com/forums/viewtopic.php?f=6&t=4774

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.