Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

The graphs can show a cancellation but the remote leds light up using Spooky Boost.

The third window of the waveforms' graph, is the waveform produced by the Spooky boost if Out1 and Out2 are in sync.

If you choose follow Out1 and use the boost cable, then cancellation occurs, and you have no output. Unless you set something in the Out2 control pane.

If the graph show cancellation and you're not using the boost cable, you still have signals in Out1 and Out2, and if you have remotes in each of them, the leds will light up.

For more details, please check the link:
http://www.spooky2.com/forums/viewtopic.php?f=6&t=3828

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.