Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

In the guide it says to use two red cables if you do not have the Spooky boost 2.0. So if I use two alligator clips from out 1 and out 2 do I change the settings from inverse sync to follow out 1?

Yes, you can use the old Spooky Boost instead of the new Spooky Boost 2.0, but if you do so, you must use a 10KOhm resistor, because the older Boost cable hasn't it inside.

For more details, please check:
http://www.spooky2.com/forums/viewtopic.php?f=39&t=4076&sid=59be13dddd6510faba8f1520d898eed8

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.