I've read your website and I understood your generator is driven by Spooky2 software from and usb cable and that your generator output is a coax cable? Did I understood right?

Articles in this section

• Is USB cable required for an UDB generator? Can the UDB connected to the PC without problems?
• Can UDB1108S run on Windows 8.1?
• UDB doesn't get detected. The driver is installed.
• Can you tell me what firmware number of UDB1108S? Are they the 4.2 that require the special Spooky software or the other standard ones?
• How do I upgrade my Spooky Remote v1.0 to Spooky Remote v1.1. Do you have instruction?
• Could the generator UDB1108S be used to make collodial silver and when the magnetic stirrer would be available? 
• I've read your website and I understood your generator is driven by Spooky2 software from and usb cable and that your generator output is a coax cable? Did I understood right?
• I've made a preamplifier (with an oap) to connect to my handholds using Frex. Can I connect your UDB1108S with it?
• Can your UDB1108S generator make high frequencies (my FreX with my laptop audio card can't go up to 22,000 hz)?
• Can your UDB1108S generator be connected to stainless handholds I already have (working now with FreX)?