Disclaimer: The information on this website is for education purposes only, and is not intended to replace the medical advice, diagnosis, or recommendations of your physician or healthcare provider. This site makes no claims that products, therapies, or services herein will cure disease. The views expressed on this website are those of our users. We may not share the same views.

Why "Data Error" comes up and my biofeedback scan stalls for a few seconds then continues and the permanently stalls?

Spooky2 Biofeedback determines the body’s response to applied frequencies. At times these frequencies interfere with the sensitive electronics built into Spooky2 Pulse. Spooky2 can filter out most of the unwanted signals, but occasionally there are too many to filter out, and an error message is reported.

Data is regarded as erroneous if the HRV is greater than 20 between 2 heartbeats. If the error message is reported Spooky2 will disregard the data but will automatically recover on the next heartbeat.

We recommend all to fully relax when using Spooky2 pulse for biofeedback scan. A quiet room with a bed is needed.

Also sometimes finger clip gets a better result than ear clips.

You may consider running the biofeedback from a narrower frequency range. Here is some info you may find useful for setting the frequency range:

Moulds and mycotoxins 75 - 215KHz
Bacteria and most viruses 275 - 450KHz
Protozoa, roundworm, and flatworm 325 - 480KHz
Warts 400 - 475KHz
Tapeworms 425 - 515KHz
Mites 675 - 880KHz

Have more questions? Submit a request


Please sign in to leave a comment.